Choose a category
Home / • NEW • / DUAL COLOR + STROBE - LED POSITION LIGHT GRILL SPOTLIGHT - SCANIA 2016+

DUAL COLOR + STROBE - LED POSITION LIGHT GRILL SPOTLIGHT - SCANIA 2016+

FLITSER SCANIA GRILL VERSTRALER DUAL COLOR + STROBE - LED POSITION LIGHT GRILL SPOTLIGHT - SCANIA 2016+ DUAL COLOR + STROBE - LED POSITION LIGHT GRILL SPOTLIGHT - SCANIA 2016+
FLITSER SCANIA GRILL VERSTRALER DUAL COLOR + STROBE - LED POSITION LIGHT GRILL SPOTLIGHT - SCANIA 2016+ DUAL COLOR + STROBE - LED POSITION LIGHT GRILL SPOTLIGHT - SCANIA 2016+
DUAL COLOR + STROBE - LED POSITION LIGHT GRILL SPOTLIGHT - SCANIA 2016+
0 Reviews | Add review
For the Scania Nextgen grill - an orange or white position light with a bright orange flash function

Product number

240912-AM

€ 289,99 *
€ 249,99 *
Price per set (left + right)
The number of Credit points granted for this product is 9
Quantity: 
Order
 
There is a 6 meter cord on the light sources with M8 connectors that connect to the included controller. The controller controls the two colors and automatically switches off the position light when you switch on the strobe light. The controller has a cable of 3 meters. The cable has 4 wires:

Green = Minus
White = Plus for white position light
Yellow = Plus for yellow position light
Brown  = Plus for strobe light

There is a 6 meter cord on the light board with M8 connectors that connect to the included controller. The controller controls the two colors and automatically switches off the position light when you switch on the strobe light. The controller has a cable of 3 meters. The cable has 4 wires:

Minus
Plus for white position light
Plus for yellow position light
Plus for strobe lights.

When it's necessary to cut the cables with M8 connectors during installation, so it is important that this joint get's waterproof connected and that the colors of the wires are properly reconnected.

Mounting:
The light source is not easy to mount, and requires extreme care when opening the lamp. If you are not sure please consult a professional!

The cooling plate must be removed as a screw, clipped and glued. There is a thin flex print inside the lamp, which you can easily cut across. Avoid getting the blade of the knife in too far.

When the heat sink has been removed, the light source must be mounted in the top of the lamp by drilling two holes through which the circuit board is then screwed. A drilling template for the purpose is included.

Finally, you must be very careful when closing the lamp again, to avoid penetrating water and moisture in the lamp.

Order by:

No reviews found.

Menu
Zoeken
Wishlist
Account
menu icon
Cart