Does a mounting magnet not work on your hubs? Then this is the perfect solution!
The set consists of:
- 1 flat mounting plate with screw end and locknut
- 1 bag of 2-component epoxy glue
- 1 mixing stick
- The mounting plate with screw end is glued to the hub by means of flat mounting.
- The bonding takes place by means of a special 2-component epoxy glue.
- There is a lock nut on the screw end that ensures that the spinner cannot be tightened too much, which can damage it.
Assembly manual:
1 - For maximum strength it is recommended to lightly sand the surface.
2 - Thoroughly clean the surface to be bonded and free of grease.
3 - Mix the two components (resin and hardener 1:1) very well with the supplied mixing sticks
4 - Apply the adhesive evenly on both surfaces
5 - Within 2 minutes, place the spinner in the center of the hub
6 - Make sure the spinner or hub does not move while drying out
7 - let the glue cure for at least 1 hour
- Use at your own risk!
Truckjunkie is not responsible for incorrect use or incorrect assembly and any resulting damage.
Pay attention! Spinners are not included
